MIL-DTL-26202E
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. These lights are intended for use as runway, approach, and taxiway lights within
the pavement of runways, thresholds, overrun areas and taxiways.
6.2 Acquisition requirements. Acquisition documents should specify the following:
(a)
Title, number, and date of this specification.
(b)
MS Part No. (see 1.2).
(c)
Data requirements (see 3.2).
(d)
Whether lamps should be furnished with the light (see 3.5.9).
(e)
Whether transformers should be furnished with the light (see 3.5.6).
(f)
Whether the MS24526 base should be furnished with the light (see 3.5.8.1.1).
(g)
Whether filters are to be provided and the color desired (see 3.5.8.7).
(h)
Brief, but complete installation, leveling, and aiming instructions be furnished with each
light. The contents of the sheet will be subject to approval by the activity responsible for
qualification prior to shipment of any light (see 4.2.1).
(i)
Packaging requirements (see 5.1).
(j)
When test samples are to be forwarded to activity responsible for qualification (see 4.2.1).
(k)
Housing material, if other than as specified in 3.5.8.1.
6.3 Qualification. With respect to products requiring qualification, awards will be made only for such
products to have, prior to the time set for opening of bids, been tested and approved for inclusion in
the applicable Qualified Products List, whether or not such products have actually been so listed by
that date. The attention of the suppliers is called to this requirement, and manufacturers are urged to
arrange to have the products that they propose to offer to the Federal Government tested for
qualification in order that they may be eligible to be awarded contracts or orders for the products
covered by this specification.
6.4 The qualified Products List (QPL) associated with this inactive for new design specification will be
maintained until acquisition of the product is no longer required whereupon the specification and QPL
will be canceled.
6.5 Preparation of test report. The test report should be prepared in accordance with the guidance of
MIL-HDBK-831.
6.6 Subject term (key word) listing.
Base-mounted lights
Bidirectional, base-mounted lights
Unidirectional, base-mounted lights
6.7 Changes from previous issue. Asterisks or vertical lines are not used in this revision to identify
changes with respect to the previous issue due to the extensiveness of the changes.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business