MIL-DTL-12216D
4.4.1 Examination. The reflectors and shields shall be examined for the following
defects:
101.
Nonconformance to the dimensions shown on the drawing.
102.
Parts or components missing.
103.
Misalignment of parts or components.
104.
Materials or components not as specified.
105.
Treatment and painting not as specified.
106.
Identification markings not as specified.
107.
Workmanship not as specified.
4.4.2
Tests.
4.4.2.1 Reflective efficiency. The reflective efficiency of the reflector shall be
determined by the absorption of light of a reflected collimated beam or other suitable
source. The loss of light in the process of reflection shall be determined by comparing
the light reflected (in foot candles) with the light projected (in foot candles) upon the
reflector surface and expressing the result as a percentage. A reflection factor of less than
70 percent shall constitute failure of this test.
4.4.2.2 Shield strength. The shield shall be extended to its full length and suspended
vertically in the normal use position from a lamp holder or with the top segment
otherwise securely fixed. Four 5-pound weights shall be suspended without impact at
uniform intervals from the flange of the bottom section of the shield for 5 minutes. The
weights shall then be removed and the shield telescoped. Failure to telescope correctly,
or any evidence of separation or other permanent deformation shall constitute failure of
this test.
5.
PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as
specified in the contract or order (see 6.2). When packaging of material is to be
performed by DoD or in-house contractor personnel, these personnel need to contact the
responsible packaging activity to ascertain packaging requirements. Packaging
requirements are maintained by the Inventory Control Point's packaging activities within
the Military Services or Defense Agency, or within the military service's system
commands. Packaging data retrieval is available from the managing Military
Department's or Defense Agency's automated packaging files, CD-ROM products, or by
contacting the responsible packaging activity.
6.
NOTES
(This section contains information of a general or explanatory nature that may be helpful,
but is not mandatory.)
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business